TO SERVICE O-RINGS
Of the housing Main O-Ring, Ports and Extension Rings
1.
Remove the O-ring. It is important never to use a sharp instrument when removing an O-ring as this may
damage the O-ring groove or the O-ring itself. A bobby pin or edge of a credit card works well.
2.
Once the O-ring is removed, it should be examined for damage. Check to make sure that the O-ring is free
of nicks and cuts and that it retains its original round profile. O-rings that appear to be damaged should be
discarded immediately and replaced with new O-rings.
3.
Rinse the O-ring with fresh water and dry it with a clean lint free cloth.
4.
Clean the O-ring groove (where the O-ring sits) with a Q-tip. Be sure to remove any lint the Q-tip may leave
behind. Inspect the groove for damage.
5.
Wipe the part of the housing that the O-ring seals against with a clean lint-free cloth.
6.
Re-grease the O-ring with a thin layer of O-ring grease until it appears to be smooth and shiny. Do not over
grease it. Use just enough grease so the O-ring will pull smoothly through your fingers. Excessive amounts
of grease will only serve to attract dirt to the o-ring.
7.
Make sure that the O-ring is properly (evenly) installed in the O-ring groove.
8.
To reinstall the clean and lubricated O-ring, place the entire O-ring over the groove and start by pushing the
O-ring in at each corner then, push the O-ring at each side and finally, work in the rest of the O-ring. Never
start at one end and work your way around the O-ring. This places uneven tension on the O-ring which may
cause the O-ring to stretch resulting in excess O-ring, which will have no place to go.
There are internal O-rings on the housing controls as well. These O-rings are not as susceptible to damage as they are
not exposed but they do require yearly maintenance and are not user serviceable. The housing should be returned to
AQUATICA or to an authorized AQUATICA service facility for this annual maintenance.
Check the Web site www.aquatic.ca for the closest service center.
An internal moisture alarm is available for your AQUATICA A300 housing (Product # 18796). This alarm is
available through your authorized AQUATICA dealer and can be easily installed.
WARRANTY
All AQUATICA products are guaranteed against defects in material or workmanship for (1) one full year from the
date of purchase for consumer use. These same products when used commercially will carry a 90-day warranty. No
statutory warranty applies. Camera housed in AQUATICA housings are not covered under this warranty and
ANY
WATER DAMAGE SUSTAINED DUE TO INSTALLATION ERROR OR FOR ANY OTHER REASON IS
NOT THE RESPONSIBILITY OF AQUATICA
. Therefore the appropriate insurance should be maintained by the
user"
