The AQ-SWA8-6BT requires a wiring harness in order to connect to power and speakers.
All open wire connections should be soldered and protected against water and dust for best long
term performance.
1. You will need an Aquatic AV AQ-UNH-2 wiring harness or the factory harness on your stereo
system to complete the install.
2. Follow the Wiring Harness diagram below. Use a minimum of 18 gauge wire for power and
ground.
3. When the unit is powered on you will see the LED light up green on the control panel.
3.1 Connecting the Combined Stereo Subwoofer
RCA Input (Red & White)
Green Power LED
Variable Voltage Input Selector
Wiring Harness
connections (see below)
Halo Aerial Technology
Connector
3.2 Wiring Harness
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
Locker.
Make sure the polarity of speakers are
connected correctly.
Power Antenna (7)
Fuse Box
d
No lower than a 4 Ohm speaker should be
used or damage may occur to the Combined
Stereo Subwoofer.
Make sure the polarity of speakers are
connected correctly.
(White/strip)
Left Rear Speaker
Right Front Speaker
Right Rear Speaker
(
i /
i )
(White/strip)
Left Rear Speaker
OPTIONAL
Right Rear Speaker
OPTIONAL
Left Front Speaker
Remote Control (optional)
Connection
4 Ohm
4 Ohm
4 Ohm
4 Ohm
Installation & Wiring
Combined Bluetooth Stereo Subwoofer AQ-SWA8-6BT
5
www.aquaticav.com