1. Make sure the outside surface is clean and
clear of debris.
2. The BlueCube Media Player has four (4) front
screws. Drive the screws using a screw driver.
Make sure screws are snug and do not over
tighten.
1.4. Mounting the BlueCube Media Player
1.5 Bluetooth Antenna Installation
1. Screw on the provided Bluetooth Antenna,
avoiding bending the cable at a 90° angle.
2. Install the Bluetooth antenna as high as
possible, above the waterline of the spa if possible,
and making sure the arrow is pointing directly
upwards towards the sky to ensure the Bluetooth
range is maximized. If there is no suitable surface
to screw it in, we recommend using a good quality
double sided tape.
1.6 Power Attenuation Wires
The AQ-BC-6BT-X Bluecube Media Player’s
power can be reduced or increased to suit
different applications. An output level
of -3dB or -6dB should be used to avoid
blowing very small speakers, often used in
spa applications.
By cutting only the white wire the output level will decrease to -6dB below the nominal 0dB.
By cutting both the white and black wires the power/volume will increase to +6dB above the
nominal 0dB.
By cutting only the black wire the power/volume will increase from -3dB to the nominal 0dB.
These modifications should only be carried out by an experienced audio installer.
Black Wire
White Wire
Output Level
Intact (not cut)
Intact (not cut)
-3dB
Intact (not cut)
Cut
-6dB
Cut
Intact (not cut)
0dB (reference)
Cut
Cut
+6dB
Should you cut the wrong wires or wish to reconnect them to further alter the attenuation, the Power Attenuation
Wires can be crimped back together.
Getting Started
BlueCube Media Player AQ-BC-6BT-X
5
www.aquaticav.com
