The optional remote AQ-RF-6UBT (sold separately) has a built-in Polymer Lithium recharge-
able battery and comes with a charging cable. Connect one end of the charging cable to the
charging connection on remote control and connect the USB end of the charging cable to
any USB charger (5V DC) for charging.
Make sure the remote has been charged before used.
1.9 Handheld Remote Control Charging
The optional remote AQ-RF-6UBT (sold separately) should include the RF receiver (AQ-RF-
6UBT-R) and should already be paired from the factory. Plug the RF receiver into the remote
control 8-pin DIN connections on the BlueCube Media Player. If you need to synchronize the
remote, follow the steps below.
1. Make sure BlueCube Media Player is powered ON (red LED)
2. Put the remote within 0.5 meter of the BlueCube Media Player.
3. Press and hold MODE on remote control until the LCD shows “Pairing in Progress”. Re-
lease the button.
4. Within 2 seconds, the LCD will show “Paired”. If it fails to pair, the LCD will show “Retry
again”. If this happens, wait 5 seconds and repeat steps above.
For any additional remote controls, you will also need to synchronize those remote controls to
the BlueCube Media Player.
1.10 Handheld Remote Control Synchronizing
If the pairing process is not successful, try again to put your remote close to the remote receiver or charge the remote
control if the battery is low.
Depending on the frequency of usage, the remote may drain its battery. Please charge the remote before use. If the LCD
shows nothing, the battery has been drained and will need charging.
If you have lost or damaged your remote control and buy a new remote control, follow the above steps to pair the
new remote control.
Getting Started
BlueCube Media Player AQ-BC-6BT-X
7
www.aquaticav.com
