AquaPur 79821, Руководство по эксплуатации

Страница: 51 / 70

48
ADR 1300 B3
GB
MT
To extend the optimal functioning of the appliance, mix the mains water with
distilled water as per the following table.
Water hardness
Ratios - distilled water to
mains water
very soft / soft 0
medium 1:1
hard 2:1
very hard 3:1
The water hardness level can be queried at your local water works.
4) Replace the lid on the water tank
3
.
5) Place the water tank
3
slightly off set below the appliance, so that the mark-
ing on the water tank points to the open lock on the appliance.
6) Turn the water tank
3
so far that the marking points to the closed lock .
Thereby, ensure that the hose that sucks the water up is always lying in the
front area of the water tank
3
. If you do not, it may happen that during use
some water will remain in the water tank
3
.
Taking the appliance into use
1) Insert the plug into a mains power socket. The red control lamp
6
glows.
2) As soon as the appliance is ready for use the green control lamp
7
starts to
glow - the red control lamp
6
continues to glow.
NOTICE
► During the heating up period it can happen that there is an occasional
escape of steam from the steam nozzle
0
.
3) Press the steam lever
1
downwards. The pump pumps water into the heater
element, steam is generated and exits from the steam nozzle
0
. Should the
steam blast subside, continue to hold the steam lever
1
down. More water
is pumped in and after a short time the steam vapour level increases.
NOTICE
► If water drips from the steam nozzle
0
during operation, release the
steam lever
1
. The appliance must fi rst heat up again. Wait until the green
control lamp
7
glows again..
WARNING! RISK OF INJURY!
► Should you leave the switched on appliance unused for an extended
period, although the steam lever
1
is not pressed it can happen that steam
escapes!