Does not vacuum as well as it should
l
Check to see if the Filter Bag is thoroughly clean.
Use the Fine Filter Bag to trap smaller debris such as algae, bacteria and silt. Use the Mesh Filter Bag (sold separately) to trap
larger debris such as leaves, acorns, twigs and pine needles. It may be necessary to rinse the Filter Bag in a bucket of clean water. Rinse,
then squeeze dry and repeat until the rinse water becomes clear.
l
Check to see if the Intake Valve Flaps on the Bottom Lid Assembly of the cleaner is free to open and close. These Flaps should move
easily to allow the entry of water and debris.
l
If you are not satisfied yet, remove the Bag, and reinstall the Bottom Lid, and run it in the poolwithout the bag. If it moves quickly, your Bag
is not clean enough, and you must repeat the cleaning instructions until the Bag is clean.
Does not cover the entire pool
l
Check to see if the Wheel movement is free of obstructions like hair, string or accumulated debris.
l
Check to see if the Filter Bag is clean and not clogged with debris.
l
Adjust the timing cycle so that the cleaner reaches the other side of the Pool and stays at the opposing pool wall for at least 2 seconds
before reversing direction.
l
Check to see if the Floating Cable is tangled, or hooked on, anything not allowing free movement of the cleaner.
Does not reverse direction
l
Take a garden hose with the pressure set on “high”, spray it into the Jet Valve Housing at each opening. This should free the Jet Valve
System of any debris. If this does not solve the problem, there is most likely debris wrapped around the impeller beneath the Jet Valve.
Cleaning The Impeller
l
Remove Valve Extensiont (2 horizontal screws)
l
Bend a common “giant” paper clip into a hook as shown in (fig. 16) Push the center flap back, look at the Impeller.
You may find debris like hair, string or a small twig caught in the Impeller. Use your paper clip to hook or free the
debris, and remove it as shown in (Fig. 18)
Reverses before reaching the opposite end of the pool
l
Turn the Time Control Dial (located on the Power Supply) clockwise a few degrees to increase the time between reversals. Repeat if
necessary.
l
Check to see if the Filter Bag is thoroughly clean and installed properly.
Waits too long at the side of the pool before reversing
l
Turn the Time Control Dial on the Power Supply counter-clockwise a few degrees. Repeat if necessary.
Floating cable is twisting
l
Your new automatic pool cleaner was designed to clean most pools without any issues, however some shapes of pools may cause the cable
to coil, tangle or twist in the opposite direction . This cleaner operates in a systematic cleaning pattern that is circular in nature, and will not cause
any twisting if you change the Lock Pin location, as instructed. Remember to change the Lock Pin location periodically to cause the cleaner to
work in the opposite circular direction and avoid the cable being twisted.
NOTE:
TROUBLESHOOTING
For Technical Support Please Call
1-800-845-4856 Or You Can Visit Us On The Web
At www.AquaProducts.com/Service
Impeller
