Aquametro Oil & Marine Viscosity VC312, Инструкция по установке и эксплуатации

Страница: 3 / 32

VCS – Viscosity Controller 3
1 Introduction
Thank you for your decision to work with Aquametro Oil & Marine Viscosity Control System (VCS).
This manual describes the installation, commissioning and use of Viscosity Control System. For additional
information, please contact your local sales agent info@aquametro-oil-marine.com / www.aquametro-oil-
marine.com .
1.1 Liability disclaimer
The manufacturer cannot monitor the compliance to this manual as well as the conditions and methods during
the installation, operation, usage and maintenance of the system regulator.
Improper installation can cause damages and endanger people. Therefore, we assume no responsibility and
liability for losses, damages or costs that result due to incorrect installation, improper operation, usage and
maintenance or in any manner associated therewith. Similarly, we assume no responsibility for patent right or
other right infringements of third parties caused by usage of this system regulator. The manufacturer reserves
the right, without prior notification, to make modifications concerning the product, technical data or installation
and operating manual.
1.2 Safety precautions
Viscosity Control System must only be used for its intended purpose and comply with local and international
safety regulations. All documentation is to be followed exactly. None of the information stated here or
elsewhere releases planners, installers and operators from their own careful and comprehensive assessment of
the respective plant configuration in terms of functional capability and operational safety.
Local applicable working regulations must be complied with, during all work on the plant and/or ship.
All safety-, installation- and operation instruction as described in this manual must be followed.
Sensors, actuators and control valves are sensitive instruments and should be treated carefully.
When removing or reinstalling sensors or components from the Viscosity Control System, safety instructions
in the respective operating manual must be followed.
Check the Viscosity Control System periodically for tightness of the connections and for proper functioning.
The unit must be installed to 110 VAC or 230 VAC according to wiring diagram.
Electrical wiring and installations are subject to statutory regulations, which must be taken into account
when planning the system.
Viscosity Control System is not for installation in zones subject to explosion hazards.
If work is to be done on the installation, before each intervention release the pressure in the installation
This manual provides instruction for installation, start-up and operation of Aquametro Oil & Marine Viscosity
Control System.
It is essential that this manual be thoroughly reviewed, with full comprehension of the
matters explained herein, before attempting installation and start-up.
The materials and workmanship incorporated into the Aquametro Oil & Marine Viscosity Control System are
designed to provide trouble-free service throughout the equipment lifetime. However, like any rotating
equipment, satisfactory performance depends on correct initial sizing, proper installation and periodic
inspection, monitoring of operating conditions (pressure, temperature, vibration, flow and electric power) and
prescribed maintenance. This manual has been prepared to assist the operator in understanding the workings of
the Viscosity Control System and provide direction for proper installation, start-up, operation and maintenance.