Aquametro Oil & Marine Viscosity VC312, Инструкция по установке и эксплуатации

Страница: 15 / 32

VCS – Viscosity Controller 15
5 Maintenance and repair
5.1 Calibration
All our Viscomaster Systems are calibrated in the factory.
An accuracy check and recalibration is offered at Aquametro Oil & Marine, this is usually dependent on
customer, operator or regulation requirements. This interval depends largely on the operating conditions,
process liquid and the application the system is installed in.
5.2 Service maintenance
CAUTION
The surfaces of the device/system and the medium may be hot.
Risk of burns!
Carry out work only on cooled devices/systems.
Work may only be performed by authorized specialists in accordance with
the applicable regulations.
Use appropriate protective equipment.
WARNING
The device/system may be under pressure.
Risk of severe injury!
Carry out work only on non-pressurized devices/systems.
When working on the device/system watch out for leaking medium.
Work may only be performed by authorized specialists in accordance with
the applicable regulations.
Use appropriate protective equipment, particularly safety goggles
WARNING
The device/system may be under high voltage.
Risk of severe injury!
Carry out work only on non-powered devices/systems.
When working on the device/system watch out for faulty isolation or open
cable cores and ends.
Work may only be performed by authorized specialists in accordance with
the applicable regulations.
Use appropriate protective equipment
Use of unsuitable cleaning agents and procedures.
Risk of malfunction or damage!
Follow the cleaning instructions on the next page.