Limited Warranty
This controller has a one (1) year limited warranty.
Aqua Logic, Inc. warrants this temperature controller to be free of
defects in materials or workmanship for a period of one (1) year from
the date of purchase. In the event of a defect or failure of this product,
RETURN THE CONTROLLER WITH PROPER PACKAGING along
with pre-authorized issued RMA number, proof of purchase and / or a
copy of the original bill of sale to the address below, freight prepaid.
COD shipments will be refused. After inspection, to ascertain that
there is a defect due to material or workmanship and that the product
is still under warranty, Aqua Logic will repair or replace the product at
our discretion and return ship the unit, Our liability is limited to the
cost of defective materials. In no case will Aqua Logic assume liability
for consequential damage resulting from any failure. Not covered by
this warranty are damage due to corrosion, abuse, accidental,
alterations, unreasonable or improper use. Aqua Logic is not liable for
payment or field repair work without prior written authorization.
Call or email Aqua Logic for a RMA number.
PH: 858.292.4773
email to: [email protected]
Return the controller to this address below with a copy of the RMA
inside the box within 30 days to:
Aqua Logic, Inc.
Attn: Return Dept. RMA# (put your number here)
9558 Camino Ruiz.
San Diego, CA. 92126
Temperature Differential:
When the water has reached the set point temperature, the chiller or
heater will switch off and will not switch back on until the water
temperature has changed by 1
°
F. This value is known as the
temperature differential between on and off cycles. Refer to the
temperature control parameters table to change the settings.
Display Calibration and Program Parameters
If the displayed water temperature on the control is different from the
system water temperature, than an adjustment to the control can be
done. The easiest way to calibrate the control is to press and hold the
"Set" button for 8 seconds. The parameter “O” will be displayed. Wait
4 seconds. Then press the “SET” button and the “SP1” will be
displayed. Use the down
▼ or up ▲ arrow until you see the menu
parameter "P1". Then press the “SET” button one time. The display
will show “0”. Press the up or down arrows to adjust to the
temperature offset. Once you have set the correct temperature offset,
press "SET" button one more time and then wait 1 minute or press
the “SET” and the “DOWN”
▼ arrow buttons at the same time to quit
the programming. The display should return to the water temperature.
The display should read correct water temperature readout.
See page 3 “TEMPERATURE CONTROL PROGRAMMABLE
PARAMETERS TABLE” to change other settings
To adjust other parameters in the control contact Aqua Logic, Inc. for
help.
PH: 858.292.4773 or email: [email protected]
5
2
