Connecting
The controller will display a Wifi symbol and have the
message “Connecting”. This indicates that the Aqualisa
SmartValve
TM
is connecting to the Aqualisa app.
The message "Connected" will briefly flash up on the
controller screen followed by a
To exit the controller menu, either rotate the
temperature bezel or allow the Settings menu
to time out.
If connection is unsuccessful a message will appear
in your Aqualisa app. Redo the steps above or refer
to app trouble shooting on page 23 or at
www.aqualisa.co.uk/smartapp.
Set up Shower - Wifi
The Aqualisa app will direct you to the Wifi settings menu on your
mobile device.
From the list of available Networks select:
QSVC XXXX
The password is:
SmartShower (case sensitive).
N.B. Depending on signal strength, the connection may take a few
minutes. You do not need to wait for connection confirmation. Go
back to the Aqualisa app and follow the steps, for these stages you
will need your home Wifi SSID code and password.
Set up Shower - Controller
Wake the controller and navigate to the Settings Menu.
From the settings menu, navigate to and select the Wifi setting.
Following the instruction on the screen of the controller – push
the lever to connect.
16
