Aqualisa iSYSTEM SMART, Руководство пользователя

Страница: 16 / 20

Temperature too
hot
Seasonal conditions In the warmer months, the mains water
temperature can rise to ambient level. The
Aqualisa SmartValve
TM
always blends a mix of
both hot and cold supplies therefore the output
temperature at fully cold (controller setting)
will always be higher than the incoming cold
water supply.
Seasonal conditions
(gravity fed systems
only)
For installations which utilise a cold water
storage supply (gravity fed system), the
ambient temperature in the loft can rise to
above 40ºC. In turn, this warms the stored
water. Check by running a cold tap that is
supplied from the water storage. N.B. Kitchen
taps are normally fed from the mains water
system.
Maximum
temperature setting
is not to your
preference
Settings need
adjusting
Refer to section 'Temperature too low', possible
cause 'Logic module setting too low'.
Controller remains
illuminated after
switching shower
off
Poor cable connection Check data cable connections are making good
contact and are fully inserted and that there
is no visible damage (this includes installations
where a wired remote is fitted).
Water flows
from incorrect
outlet (divert
models only)
Primary outlet setting
not configured
Refer to section: Diverter Controller Matrix
in the main product (Aqualisa SmartValve™)
installation guide.
Water dripping
from outlets
after use
Water retention in
shower heads
Refer to page 6.
Descale shower heads to clear spray jets.
High pressure
(unvented) water system
requires servicing
Check the user guide for the hot water system
to verify symptoms and where required arrange
for servicing.
Flow shuts off
by itself
Maximum run time
exceeded or end of
duration reached in app
timer setting
Refer to pages 4, 5 and 11.
For further information and advice refer to main product (Aqualisa SmartValve™)
installation guide or contact the Aqualisa Customer Helpline.
16