Aqualisa iSYSTEM SMART, Руководство пользователя

Страница: 14 / 20

Low / no flow Seasonal conditions See previous point.
Incorrect Aqualisa
SmartValve
TM
fitted
If water supplies are gravity fed, the PUMPED
Aqualisa SmartValve
TM
must be used (unless
a separate stand alone pump is being
utilised). Refer to the main product (Aqualisa
SmartValve™) installation guide.
Water supply issue For Standard Aqualisa SmartValve
TM
- Ensure water
is turned fully on at the mains and at the servicing
valve in the supply.
Ensure isolation valves are fully open.
Restriction in the
waterway
See same cause in 'Pump noisy and low / no flow'
symptom.
Blocked or kinked
hose liner
Where a flexible hose is fitted, unscrew the
shower hose from the outlet connection and
turn the shower on.
Incoming mains water
pressure or flow too
low (Standard Aqualisa
SmartValve
TM
only)
After confirming that the filters are clear, check
with the local water authority.
Separate, stand alone
pump not activating
(Standard Aqualisa
SmartValve
TM
only)
Ensure sufficient flow to activate the flow
switches of the pump. Refer to IMPORTANT
INFORMATION section in the main product
(Aqualisa SmartValve™) installation guide.
Aqualisa SmartValve
TM
pump not activating
Refer to Setting Water System Mode section
in the main product (Aqualisa SmartValve™)
installation guide. Ensure mode is set to Normal
or ECO Gravity setting.
Aqualisa SmartValve
TM
is set to ECO mode
Refer to the above point.
Unable to adjust or
control temperature
Reversed inlet water
supplies (i.e. Hot
supply feeding cold
inlet and vice-versa)
Ensure correct water supply to specified inlet
connection of the Aqualisa SmartValve
TM
.
14