Axis Digital concealed
installation instuctions
page 7
Run a pipe from the mixed water outlet on the Digital processor through the
wall or ceiling to the proposed siting for the shower hose outlet, fixed head or
diverter depending on the system purchased.
7
Feed the cable from the back of the control
and connect it to the cable on the processor.
Tuck the remainder of the cable into the
control before securing it onto the
mounting bracket.
10
Place the mounting bracket on the wall in the
desired location for the control and mark the
position of the three fixing holes and the data
cable entry point. Remove the bracket and drill
a ø16mm hole at the appropriate position for
the data cable.
8
The data cable should be run in conduit to allow for servicing and upgrading
!
Drill and prepare suitable wall fixings for the two control mounting screws.
Secure the mounting bracket using the screws supplied in screw pack no. 2
(if suitable).
9
To finally secure the control, tighten the
captive screw at the base of the control using
a small Posidrive screwdriver.
11
Connect the low voltage data cable to the
Digital processor via the socket located under
the black protective flap. Feed the cable out of
the processor by threading it under the small
red lip to the left of the socket, then screw the
flap back down to provide a watertight seal.
12
Please refer to the reverse of this guide for installation of your shower head.
!
