Axis Digital concealed
installation instuctions
page 16
Insert the red 3/8” BSP plug
into the front of the spigot
and tighten. Turn on the
shower valve to pressurise
the system and thoroughly
check the outlet assembly
for any leaks.
3
Ensuring that the spigot
‘O’ ring is clean and slightly
lubricated (using a silicone
based lubricant or
petroleum jelly), slide the
fixed head arm over the
mounting spigot until it
meets the wall surface.
7
Turn off the valve and leave the plug in place to prevent
ingress of debris during the making good process. No parts
of the shower system should be cemented into the wall.
4
Slide the cover plate carefully down the fixed head arm
to give clear access to the fixing plate.
5
Carefully remove the plug from the fixing spigot,
remembering that the system contains water that may
be under pressure.
6
Set the arm into position
and mark the fixing points.
Remove the arm and drill
and prepare suitable wall
fixings. Refit the arm and
secure it to the wall using
the screws provided if
suitable.
8
