Axis Digital concealed
installation instuctions
page 13
Ceiling flush mounted
The ceiling flush mounted fixed head is supplied with screws
for fixing the product to a noggin.
A NOGGIN MUST BE USED AS PART OF THIS INSTALLATION
Before starting installation of the flush mounted fixed head
it is imperative that the installation notes below are read and
understood and that checks are made to ensure that there
is sufficient space behind the ceiling as required.
!
Run a 15mm outlet pipe from the shower valve/processor
to the preferred position for the fixed head. Ensure that the
outlet is clear from debris.
1
Carefully remove the black
bezel from the shower head,
by folding back the front
edge before uncliping it
from the assembly.
2
3
The fixed head is mounted to a noggin that must be
supported across two beams.
!
Once the position for the fixed head has been finalised,
use a set of compasses or the template provided to mark
a ø123-127mm hole. Using the same center point drill a hole
(minimum 28mm, maximum 40mm) through the ceiling and
the noggin. Cut out the ø123-127mm hole.
4
Locate the position for the
fixed head in the bathroom
and firstly drill a pilot hole
to mark the position before
checking that there is
suitable space behind the
ceiling for the assembly.
