5
Lightly lift the back and carefully slide the cowl forward.
Then, remove the sub cowl.
In your boat you will find a length of hook and loop on the
battery tray. Remove the piece of hook and loop and install
onto the battery back. Install the battery into the boat like
shown in the picture.
Tuck the wires neatly under the decking.
Arming
IMPORTANT!
Always turn the transmitter ON
before
plugging in the battery.
With the transmitter on, plug a charged battery into the
controller. You will hear the motor chime, plus one beep letting
you know the motor has power. Squeeze the throttle trigger
fully and you will hear two more beeps. Relax the throttle
trigger and you will hear three beeps. The boat is now armed
and ready to run. (Note: The arming procedure has to be done
each time you plug the pack into the boat.)
LET’S REVIEW THE ARMING PROCEDURE
1.
Turn the transmitter on. You will hear a chime with a
“beep. bee-daa-beep--beep!”
2.
Squeeze the throttle trigger fully. You will hear two beeps.
“beep-beep”
.
3.
Relax the throttle trigger. You will hear three more beeps.
“beep-beep-beep”
.
4.
The boat’s power system is now armed and ready to run.
Install the sub cowl and tape it in place. This is the best
system for keeping water out of your boat. We have supplied
you with a small roll of tape (located under the boat stand) to
get you started. Re-install the main canopy using the pin to
hold it in place.
NOTE:
You can also upgrade to our premium
radio box tape, making application and removal much easier
(AQUB9514 Grimracer Pro Radio Box Tape).
