TM Reverse Osmosis Water Filtration System
Product Code: SYS-RO924TM5
Page
6
of
15
INSTALLATION PROCEDURE
Important Note: Do not cut the BLACK tube when installing this system.
1.
Find a convenient location: The System dimensions are 360W x 430 H x 320 D (mm), and the tank dimensions are 244 D x
366 H (mm). The tank can go laying down as well as the system.
2.
Shut Off the water supply: Locate the connection between the kitchen tap & cold-water line (Usually a flex line). Shut off the
incoming water and open the tap (cold water) to release the pressure.
3.
Disconnect the cold water braided hose: If you do not know which one is the hot or cold, run the hot water for a while and
feel the hoses.
FEEDING THE SYSTEM WITH HOT WATER, WILL DAMAGE THE SYSTEM
4.
Install the mains adaptor: From the cold-water inlet, install the valve adaptor/mains connector in
between. DO NOT apply thread tape to these connections as they are designed to use the
washers only. (Fig 2)
5.
Check for leaks: With the blue handle facing in line with the cold-water line (As pictured)
the valve is in the off position. During this point, you can turn the water back on to check
for leaks in the valve installation.
6.
Select location on kitchen sink to install faucet. Make sure there is adequate access under
the bench top for the hoses. The faucet supplied with the system requires a ½” (12 mm)
hole. Use a centre punch to locate the position to drill.
7.
Drill a pilot hole and gradually enlarge until you have the correct size hole.
8.
To install faucet, insert the faucet into the hole in sink or bench. The faucet may be installed on any flat surface over 50mm
(2”) in diameter. (Remember: check the underside of the location for interference). Make a small indent using a centre punch
to mark the desired drilling location. Drill a pilot hole with a metal
drill. Enlarge the hole using a 1⁄2” metal drill bit.
Once the hole has been drilled install the faucet as per Figure 4. Be sure the faucet body, chrome plate, and the black rubber
washer are placed above the sink. Install the black locating washer, the lock washer and nut underneath, then tighten firmly
while aligning faucet in the desired direction.
Connect BLUE tube to faucet. (Fig 4)
Figure 3
Figure 4
Figure 2
