Aqua Ultraviolet Ultima II Pro 3" Series, Инструкция по эксплуатации

Страница: 12 / 22

ULTIMA II INSTALLATION INSTRUCTIONS
CAUTION: The filter should be installed not more than 6 feet above pond water level, on a level surface, very
firm ground, or equivalent, as recommended by your dealer. Position the filter so that the piping connections,
and unions, control valve, and winter drain are convenient and accessible for operation, service and winterizing
(if needed).
Inspecting and Placement of the Filter
1. Check the carton for any evidence of damage due to rough handling in shipment. If the carton or any component is
damaged notify the freight carrier immediately.
2. Carefully remove the accessory package and filter tank from the carton. If any component is damaged notify the
freight carrier immediately.
3. Mount the filter on a permanent slab, preferably concrete poured in a form or on a platform constructed of concrete
block or brick. DO NOT use sand to level the filter or for pump mounting as it will wash away.
4. Provide space and lighting for routine maintenance access. Do not mount electrical controls over the filter. Leave
space to stand clear of the filter when starting the pump.
5. Position filter so that the port locations are in the desired final positions. Follow valve installation procedures.
Filter Valve Installation
PART 1: Attaching Valve Assembly to the Filter Body (Installation requires 2 people)
1. Remove the nuts and washers from flanged connections on the valve, be sure the gasket and screws remain in place
on the flanges.
2. Locate the flange connections on the filter tank body. One person can hold up the valve assembly while the second
person lines up and inserts the bolts into the flange connections on the filter body.
3. Once the bolts are in place you may then place and tighten the washers and nuts.
Note: Tighten bolts opposite each other applying even pressure to each bolt.
Once the valve is attached to the filter body you are ready to plumb the valve in-line. For your convenience the ports are
marked" Pump", "Return" and "Waste".
PART 2: Plumbing the Valve In-line
1. Glue unions, not provided, onto the valve.
2. Identify the pressure side of your pump and glue a pipe from it to the port marked "Pump".
3. Locate the return line that runs back to your pond, or other body of water, and glue that to the port marked "Return"
4. Find an area where you would like the wastewater and debris discharged. Glue a line from the port marked "Waste"
running out to the designated area.
5. Once the connections have been glued allow drying time as instructed on the glue packaging.
6. Depress the Valve handle and rotate it to the position marked "Filter".
10
AQUA ULTRAVIOLET 42371 AVENIDAALVARADO, TEMECULA, CA 92590 TEL: 951-296-3480 FAX: 951-296-3490