Aqua Phase,
A Division Mid-State Stainless Inc
. ●330 W Benson Ave. ●PO Box 228 ●Grantsburg, WI 54840 ●
USA
800-208-9274
●715
-463-
5851●FAX: 715
-463-
5853●
Email:
●WEB:
Start-up Procedures:
1.
Check that the Aqua Phase Washer is connected to a water supply and that the water supply is
turned on. Then confirm the Aqua Phase Fill and Drain Hose Connections are properly connected
and secure.
2.
Check the Primary Filter Screen inside of the Aqua Phase
Reservoir
to make sure you have a
clean Primary Filter Screen. Make sure that the screen
is put back in place properly.
3.
Check the chemical supply levels, by looking in the Chemical Cabinet – located in the back, or
side, of your Aqua Phase Washer.
4.
Plug in the Aqua Phase and press the ‘Reset’ button located on the GFCI plug.
Operating Procedures
1.
Load the item to be washed into the Wash Chamber, then close and latch the front door.
2.
Set the ‘Wash Time’ (3, 5, or 7 minutes) selector switch, located on the Control Panel, to the
desired wash time.
3.
Set the
‘Run/Drain’
selector switch to
‘Run’
.
4.
Select the Wash Mode
Only if your Aqua Phase Washer is equipped with the Disinfectant
Application System feature.
5.
Push the green
‘Start’
button located on the Control Panel. Aqua Phase Washer will now fill with
water & begin the cycle selected.
6.
When cycle is complete, open door of washer.
**
Cation when opening the door-steam will come out of the door. The door and the item washed
may be hot to the touch right away.
7.
Take the
items
out of the washer. On drying mat, tip the wheelchair on its handles to let the
water
on the seat run off
.
8.
Push the red ‘Stop’ button at any time during the cycles if problems arise.
Optional Step:
Lay out a drying mat on the floor, by the Aqua Phase Washer Door, to soak up water
when you remove items from the washer.
Shut-Down Procedures:
1.
When you are finished for the day, set the
‘Run/Dry’
selector switch to
‘Drain’
.
2.
Press the green
‘Start’
button to completely drain the water out of the washer. Door has to be
closed.
3.
Open the door and clean the debris from the Primary Filter Screen – located just inside on the
bottom of the Wash Chamber. Make sure the Filter Screen is put back in place properly.
4.
Wipe clean the High Water Level Control (located inside, on the bottom of the Washer Chamber)
clean.
5.
Wipe the Low Water Level Control (located inside, on the bottom of the Wash Chamber) clean.
6.
Turn off the water supply to the Aqua Phase Washer.
7.
Un-plug the Aqua Phase Washer form the wall/power supply.
8.
Open the front door of the Aqua Phase Washer if it will be a couple of days before next use.
DAILY OPERATIONS
PROCEDURES
15
