How to remove the battery pack
Recommended tools (not included): Philips screwdriver and small slot screwdriver
1. Turn to release the canopy and take out the filter bag / filter cage. Use a small slot screwdriver to detach the ring from the handle. If it is too
difficult to detach the ring with a screwdriver, use a cutting plier to cut. Turn the switching knob to open the charging port. Use the small slot
screwdriver to pry and detach the middle cover from the switching knob. Use the Philips screwdriver to unfasten the knob-locking screw.
2. Detach the switching knob and use the Philips screwdriver
to unscrew all the screws on the main body. Separate the
body in two halves to access the main chamber.
4. Remove the complete battery enclosure (with battery installed) from the chamber. In order to detach the battery cable, press on the clip on
the connector and pull the cable out. Wrap the connector immediately with insulating tape in order to avoid short circuit caused by the
contact of both wire terminals.
SAVE THESE INSTRUCTIONS
Distributor: Aqua EZ inc.
6100 Wheaton Dr. SW
Atlanta, Ga 30336 USA
If parts or Technical support is required, please
contact our customer service by email or phone
[email protected] 1-877-852-4264
TROUBLESHOOTING
Problem
Electric vacuum does
not capture the debris
Debris escapes from the filter
Debris escapes from the
filter bag / filter cage
Electric vacuum cannot
be charged / recharged
Pivoting suction head
(if provided) does not
move smoothly
Possible Cause
Battery is drained
Impeller is jammed
Impeller is broken
Filter is full
Canopy flap is damaged
Filter bag / filter cage is
damaged.
Battery is damaged
USB cable is damaged
USB charger (not
included) is out of order
Wheel is jammed
Solution
Charge the battery again.
Power off the electric vacuum and inspect the middle gap of the electric vacuum
to see if the impeller is jammed by larger debris. If possible, use a small tool to
remove it with intensive care & caution. If necessary, contact your dealer for
further instructions.
WARNING!
Make sure the electric vacuum is powered off when the
unit is being serviced.
Contact an authorized dealer regarding replacements.
Clean the filter.
Canopy flap works like a door to prevent the debris from escaping from the filter.
Contact dealer for replacement part and instructions.
Replace with a new filter bag / filter cage. Contact an authorized dealer regarding
replacements.
Contact an authorized dealer regarding replacements.
WARNING!
DO NOT open the electric vacuum and replace the battery
by yourself. This could result in severe or fatal injuries, as well as voiding
the warranty.
Replace with a new USB cable.
Replace with a new USB charger.
Clean out the debris from the wheel.
Note: Do not attempt to take out the wheels.
3. Use the Philips screwdriver to unfasten the screws. Remove the
top half of the chamber to expose the battery enclosure.
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly
recycles electrical and electronic equipment. Do not dispose them in unsorted waste bins.
For items containing removable batteries, remove batteries before disposing of the product.
© 2019 Aqua EZ inc.
All rights reserved. No part of this document may be reproduced or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording,
or otherwise, without prior written permission of Aqua EZ inc. (V1)
C US
