4/7
1.
Manufacturer information
AQ M-Tech AB
operates a policy of on-going development and reserves the right to make changes
and improvements to any of the products described in this manual without prior notice.
Under no circumstances shall
AQ M-Tech AB
be held responsible for any loss or indirect damage
howsoever caused. The contents of this document are provided as it is.
AQ M-Tech AB
reserves the
right to revise this document or withdraw it at any time without prior notice.
CE Declaration of Conformity
Manufacturer:
AQ M-Tech AB
Sweden declares, that the product:
Heater Jacket marked with CE-label conforms to the following standards:
EN 61000-6-2:2001, EN 61000-6-4:2001, EN55011 (Group 1, Class B).
Limited Warranty
AQ M-Tech AB
gives its end customers a warranty that the Heater Jacket is free
from defects in its materials and operation for a period of one year from the date of purchase.
Should the Heater Jacket show signs of manufacturing defects or material defects
during the warranty period,
AQ M-Tech AB
will repair or replace the defective product at no charge.
The warranty becomes void immediately should the Heater Jacket, during the warranty
period, in any way be, modified, used incorrectly or be subject to tampering, abnormal working
conditions. Such as overheating or used in any other way than what is described in this manual.
The repair or replacement of other equipment in addition to the Heater Jacket can
not be provided under the terms of this warranty.
The purchaser pays the carriage charges to
AQ M-Tech AB
.
AQ M-Tech AB
can in no way be
held liable by the purchaser for damage caused to any other equipment.
Warning
The Heating Jacket may only be connected to one Heater Jacket Control Unit intended for this purpose.
Touching the Heater Jacket while in operation should only be done while wearing protective gloves
intended for handling hot products.
Flammable or heat sensitive materials must not be found closer than 15 cm from Heater Jacket.
The symbol on the Heater Jacket
“Caution!, hot surface” figure 1, means that the surface can be scorching.
In order to avoid burn injuries, switch off the Heater Jacket and wait about 30 minutes before touching it.
When extending the Heater Jacket cables only cables supplied by
AQ M-Tech AB
may be used.
Cleaning may only be carried out when the Heater Jacket is at room temperature.
The Heater Jacket is manufactured with different supply voltages. The supply voltage to the Heater Jacket-
Control Unit is governed by the prescribed supply voltage for Heater Jacket. When the supply voltage to
the Heater Jacket Control Unit is changed, Heater Jacket must also be changed.
Heater Jacket is not approved for use in Ex-classified environments.
Manufacturer information
Manufacturer:
AQ M-Tech AB
Adress:
Bolandsgatan 10
SE-753 23 Uppsala
Sweden
Phone:
+46 (0)18-470 29 00
Fax:
+46 (0)18-10 50 04
Web:
E-mail:
Figure 1