34
Quality for Professionals
15 Accessories
15.1 MX chassis hoist sensor (Art. No.: 00410-2-008)
Connection
12-pin connector on the control module
The ES 100 M2 Special shutter opens and closes automatically.
Cable length:
5000mm
Where installed: Because most tillage implements are raised and lowered when
being used, it is best to install the sensor at, or on, the tractor's
lever arm (see figure above).
The sensor can also be installed elsewhere where there is a
mechanical movement of more than 50 mm. There should be a
distance of at least approx. 5 mm between the sensor and the
magnet.
For coupled tillage implements, the sensor can be installed on
the chassis because the hoist is not being used here. For
coupled tillage implements, the sensor can be installed on the
chassis, because the hoist is not being used.
In order to rotate the working position, the
button and
button must be
pressed at the same time.
This appears on the display:
Scope of delivery: 1 sensor, 2 magnets incl. screws/bolts, cable binders, 1 fastening
plate, 2 PVC nuts for the sensor.
Note: The sensor must not be over-tensioned.
The slider only opens when the spreading disc is running!
Fig.: 14
Three-step signal
inverted!
