APV 1.2, Руководство по эксплуатации

Страница: 9 / 16

9
Quality for Professionals
3 Status messages and possible solutions
3.1 Controller messages
Error messages must be acknowledged with the on/off button and the spreader is
then switched off.
The following error messages can be displayed:
CAUTION:
If your battery is charged by a charger that is in "Start" operating mode,
there can be voltage peaks! These can cause damage to the electrical system of
the control box if it is also connected when the battery is being charged!
Display Cause Solutions
E01
Indicates that the gear motor for the
seeding shaft is not connected. Check the cables and plugs for
faults or damage.
E02
Is displayed when the seeding shaft
cannot rotate or when the motor is
strained for too long at its limits. Turn off the implement and check
if solid substances or similar
prevent the seeding shaft or
agitator from turning or impede
their operation.
E03
Is displayed when the motor
(seeding shaft) is connected and not
overloaded, but is still blocked.
Check if there is something
blocking the seeding shaft. If this
is not the cause of the problem,
please contact Customer
Service.
E01
Indicates that the blower fan motor /
spreading
plate motor is not
connected.
Check the programming (see
Point 7) and the cabling or plug.
E02
Indicates that the blower fan motor /
spreading plate motor cannot rotate
or that the blower fan motor /
spreading plate motor is being
strained for too long at its limits. Turn off the implement and check
if objects are blocking the blower
fan / spreading plate or impeding
their operation.
E03
Is displayed when the motor (fan or
spreading plate) is connected and
not overloaded, but still does not
rotate.
For hydraulic fan with pressure
switch or pressure sensor: the fan is
not running or is not sending a signal
to the pressure switch/speed sensor. For hydraulic fan: Switch on the
hydraulic fan.
Please contact customer service.
E04
Is displayed when the operating
voltage is too low. Reduce the consumers, check
battery; check cabling, check
alternator