APV 1.2, Руководство по эксплуатации

Страница: 7 / 16

7
Quality for Professionals
2.4 Starting up the implement
After switching on the implement with the on/off button, the control lamp above the
button lights up. This shows that the supply voltage is available.
As long as the on/off button is held, the software version is displayed. E01 =Software
1.1; E02= Software 1.2. This may be necessary in case of customer service.
You can now use the rotary knob on the left to adjust the speed of the blower fan /
spreading plate. The rotary knob on the right is used to adjust the speed of the
seeding shaft.
When you press the blower fan button, the fan motor (or the spreading plate on the
MDS) will start running.
As soon as you press the seeding shaft button, the seeding shaft starts rotating at
the set speed and you can start seeding.
2.5 Operation on the field
To begin sowing, press the seeding shaft button.
1st Stage: the LED control lamp beside the blower fan button flashes (the blower fan
motor or spreading plate is starting up).
2nd Stage: after a few seconds, the LED control lamp beside the blower fan button
lights up (blower fan motor is running).
3rd Stage: when the green LED control lamp beside the seeding shaft button lights
up, the gear motor that turns the seeding shaft and conveys the seed is switched on.
When you are turning at the headlands, you only have to press the seeding shaft
button so that the green LED control lamp is turned off. This stops the seeding shaft
and only the fan motor is still running.
When finishing work, press the on/off button on the control box to switch off the fan
motor and the seeding shaft. The LEDs are turned off and the control box is switched
off.
2.6 Calibration test
First determine the required speed for the seeding shaft based on the calibration
table (this can be found in the operating manual for the spreader).
The calibration test is started by pressing and holding the seeding shaft button for
3 seconds. The implement beeps once.
PLEASE NOTE: Always ensure that the blower fan is switched off before starting the
calibration test.