-
23
-
R
AP029
English
3.11 FINAL ASSEMBLY
3.11.1 Bleeding
Warning
!
Before proceeding in setting the operator, bleed it.
Start the operator after having checked the setting
of the pressure relief valves, move it to stroke end
either in open or close position and, acting on the
screw (see fi g.
C18
), lock and release the operator
a dozens of times.
3.11.2 Adjusting the brake in close
position
Warning
!
The operator is standard supplied with cut-out
brake.
For an easy adjustment, proceed as follows:
• Retract the rod inside the operator by means of the
manual release device or by powering the operator
opening.
• Tighten the slow-down setting screw (
C19
pos.
1
)
by rotating clockwise.
• Power the operator closing (rod extension) for a
longer time than the one necessary to complete the
maneuver. The rod movement stops.
• Rotate the slow-down setting screw (
C19
pos.
1
)
counter-clockwise. Rotate slowly for max. 4 complete
turns until the rod starts moving again.
• Adjust the slowing-down as required by rotating the
screw of half-turn.
Warning
!
Do not unscrew the hydraulic brake setting screw
completely to prevent oil leakage.
3.11.3 Adjusting the brake in open
position (E9)
To use the opening slowing-down (only for ZT40 SF
DS version), it is indispensable to use the entire stroke
length of the rod.
In the ZT40 SF DS version, with the rod fully withdrawn,
12 mm will protrude.
3.11.4 Final assembly
Fit the protective casing (left or right) (
E7
pos.
2
) on to
the arm, so that it rests against the operator.
Fix the casing (
E8
pos.
3
) into position on its underside,
using a cross-head screwdriver (
E8
pos.
4
).
Fit the push-on cover (
E10
pos.
2
)on to the protective
casing (
E10
pos.
1
).
If necessary, fi t the protective sheath (
E11
pos.
7
) to
the power supply cable (
E11
pos.
6
).
AP029036
AP029035
+
mm/sec
1
AP029047
AP029046
C18
C19
E7
E8
Installation
7
6
AP029037
2
1
E10
E11
AP030051
8 mm (A,B
,C,
SF)
AP030057
12 mm (SF DS)
E9
E9
AP030054