Aprimatic 42605/001, Руководство по установке и обслуживанию

Страница: 6 / 32

5 www.Aprimatic.it
4. ASSEMBLY PROCEDURE OF THE AUTOMATION
Check the stability, the weight of the leaf and that the movement is smooth and without friction (if necessary to reinforce the
frame). Any closing door device must be removed or completely deactivated.
Check the correct operation in case of installation on doors that divide environments at different pressures.
4.1 INSTALLATION OF OVER AUTOMATION WITH SWSA SLIDING ARM
Use the sliding arm to pull with doors which open inside (view from the automation).
Remove the cover and fix the automation in a stable and leveled way to the wall using the measurements shown in the
figure; refer to the axis of the door hinges.
Fix the sliding arm on the door as shown in the figure. Insert the sliding arm in the guide and fix to the automation.
Note: if necessary, you can change the measure H, between the automation and the door, by replacing the spacer, using the
codes listed in the table .
(H) OVER automation
28 Sliding arm + Spacer 17mm
45 Sliding arm
62 Sliding arm + Spacer 51mm
Move the door manually, and verify the correct opening and closing smoothly.
Adjust the opening mechanical stop inside the sliding arm.
CLOSING OF THE AUTOMATION COVER
Insert the cover profile to the base profile and attach it to the heads. To prevent the cover from being opened without the
use of a tool, you can remove the pins inserted into the cover, and secure the cover to the heads at the holes, using the
screws 2,9 x9,5 not supplied by us.