Aprimatic 42605/001, Руководство по установке и обслуживанию, Страница: 28 / 32

27 www.Aprimatic.it
8.5 INFORMATION AND DIAGNOSTICS MENU
Using the buttons ↑ and ↓ select INFO, press ENTER to select and adjust the following information and diagnostics menu.
Display Description Factory settings
SHOW Displaying information of warning and faults. Choose between the following values:
CONT = the display shows the active contacts of the terminal blocks and the alarms.
WARN = the display shows the alarms only. CONT
VER Displaying the firmware version of electronic control (eg = 0200). ‐ ‐ ‐ ‐
CYCL Shows the number of cycles of the door (1 = 1.000 cycles, 9000 = 9.000.000 cycles). 0000
SERV Enabling the signaling of routine maintenance of the door.
NO = no signaling
1 = 1.000 cycles
9000 = 9.000.000 cycles 0000
LOG You can save the following information in the micro SD memory (swing_log.txt): the last 20 warnings, the
menu settings, and the electronic devices connected to automation. Choose between the following
values:
NO = no save
YES = save the information in the micro SD memory NO
DISPLAY FSD1 ‐ FLASH WARNING CHECK
W001 1 Encoder error Check encoder connection
W002 1 Motor short circuit Check the connection of the motor
W003 1 Motor control error Electronic control failure
W010 2 Direction reversed Check the presence of obstacles
W011 2 Running too long Check the connection between the motor and leaf
W012 2 Running too short Check the presence of obstacles
W013 2 Overrun Check the mechanical stops
W100 ‐ ‐ Programming error (CB03) Repeat the programming procedure in MEM > FW menu
W103 ‐ ‐ Programming error (FSD1) Repeat the programming procedure in SEL > FW menu
W127 ‐ ‐ Automation reset The automation performs a self ‐ test
W128
on No power supply
Check the power supply
W129
1
No battery Check the battery connection
W130
1
Low Battery Replace or recharge the battery
W140 3 6A safety test failure Check the safety sensor connection
W142 3 8A safety test failure Check the safety sensor connection
W145 4 Motor overtemperature (first step) The door reduces the speed
W146 4 Motor overtemperature (second step) The door stops
W150 2 Obstacle in opening Check the presence of obstacles
W151 2 Obstacle in closing Check the presence of obstacles
W152 2 Door locked open Check the presence of locks
W153 2 Door locked closed Check the presence of locks
W156 2 Door moved manually Wait about 5 seconds
W160 1 Synchronization error Check the ADV > SYNC menu
W256 ‐ Power on ‐
W257 ‐ Firmware update ‐
W320 on Signaling of maintenance Check the INFO > SERV menu
W330 1 Tuning between motor and electronics Wait about 3 ‐ 30 seconds