Aprimatic 42605/001, Руководство по установке и обслуживанию, Страница: 23 / 32

22 www.Aprimatic.it
8.2 MEMORY MANAGEMENT MENU
Using the buttons ↑ and ↓ select MEM, press ENTER to select and adjust the following memory management menu.
Display Description Factory settings
FSET Restore all settings to factory defaults. Choose between the following values:
NO = no restore.
YES = restore to factory settings. NO
FW Programming procedure of electronic control.
Download the electronic control Firmware, available at www.Aprimaticspa.it in Download area.
Extract the "BFDS" folder from the ".zip" file and copy it to a micro SD memory (not in subfolder). Insert
the micro SD memory in the electronic control.
From this menu, choose the firmware version you want (from 0200 to ‐ ‐ ‐ ‐ ).
Press ENTER until it starts the programming procedure that lasts about 30 seconds (the display shows
“WAIT • • • •”), at the end the display shows "SAVE".
After the procedure, remove the micro SD memory from the electronic control and store it for future
use.
Note: in the case of programming error or missing firmware (W100), proceed as follows: disconnect the
power supply, insert the micro SD memory, give power supply, the programming procedure starts
automatically.
‐ ‐ ‐ ‐
SIN You can upload the menu settings used in another automation, already stored in the micro SD memory.
Choose between the following values:
NO = no upload
YES = upload the menu settings from the micro SD memory
NO
SOUT You can save the menu settings of automation in use, in the micro SD memory. Choose between the
following values:
NO = no save
YES = save the menu settings of automation in the micro SD memory
NO