68
use and maintenance
Scarabeo 250
R
HORIZONTAL ADJUSTMENT OF
THE HEADLIGHT BEAM
To adjust the headlight horizontal beam:
u
Loosen the two screws with a
screwdriver (2).
u
Move the beam to the right or left
according to the direction of travel.
u
Tighten the two screws (2).
BULBS
Carefully read page 51 (MAINTENANCE)
Risk of fire.
K e e p f u e l a n d o t h e r f l a m m a b l e
s u b s t a n c e s a w a y f r o m e l e c t r i c
components.
Before changing a bulb, set the ignition
switch to position “
” and allow a few
minutes for the bulb to cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid any
damage.
DO NOT PULL ON THE WIRES.
NOTE
Before changing a bulb, check
the fuses, see page 67 (CHANGING THE
FUSES)
CHANGING THE TURN INDICATOR
BULBS
Carefully read on the side (BULBS)
To change the bulbs:
NOTE
The following information applies
to all turn indicators.
u
Unscrew and remove the screw (1).
Proceed with care.
Do not damage the tabs and/or their
seats.
u
Remove the lens (2).
2
2
2
3
4
1
Scarabeo250USA.book Page 68 Friday, July 22, 2005 6:17 PM
