104
use and maintenance
RSV 1000 TUONO R
CHANGING THE HEADLIGHT
BULBS
Carefully read page 103 (BULBS).
The headlight fairing is shown removed
from the vehicle for better clarity. In fact,
the high and low beam bulbs can be
replaced with the headlight fairing in place.
The headlight accommodates:
– Two high beam bulbs (1).
– Two low beam bulbs (2).
– Two parking light bulbs (3).
High beam and low beam use the same
bulbs.
If one of the bulbs (2) is damaged and no
spare bulb is available, you may replace it
with one of the bulbs (1).
This is only intended to help you ride back
home or reach the nearest parts shop.
Replace the damaged bulb as soon as
possible.
To change the bulbs:
u
Position the vehicle on the stand, see
page 56 (PLACING THE VEHICLE ON
THE STAND).
HIGH AND LOW BEAM BULBS
NOTE
Disconnect one connector at a
ti me to avoi d confusi ng the va riou s
connectors when refitting.
When high and low beam bulb connectors
must be removed at the same time, mark
them with their positions and make sure to
refit them in the correct positions on
assembly.
u
Remove the upper side cover, see page
78 (REMOVING THE SIDE FAIRINGS).
CAUTION
Do not pull on the wires to extract the
bulb connector.
u
Disconnect the connector (4).
u
Rotate the lock ring anticlockwise and
extract the bulb holder (5).
u
Fit a new bulb of equal rating.
u
Refit the bulb holder into the seat and
rotate clockwise to lock in place.
u
Refit the connector (4).
1
1
2
2
3
3
1
2
4
5
APRum_TUONO_MY05_01_UK.book Page 104 Monday, September 26, 2005 5:15 PM
