APRILIA RSV 1000 R, Руководство по ремонту

Страница: 75 / 308

FUEL SYSTEM
3 - 8
RSV 1000 R - RSV 1000 R FACTORY
Lambda sensor mV Value ranges from 300 to 3000 mV
Type 1 carburetor adjust-
ment - Tells the ECU how much air is required
in the type 1 engine load condition
Type 2 carburetor adjust-
ment - Tells the ECU how much air is required
in the type 2 engine load condition
Idling carburetor adjustment
- Tells the ECU how much air is required
in the idling engine load condition
Injection time ms
Atmospheric pressure hPa Sensor located under seat
Spark advance °
DEVICE
STATUS Fall sensor normal/
tip over
ECU valid/invalid combination The ECU supplies the valid combina-
tion signal to the dashboard when it is
installed on a compatible vehicle
Oil pressure low/
normal
Idling condition on/off Engine condition at idling (see also with
engine off)
Full load on/off Engine condition under full load (engine
must be on)
Engine kill button on/off Engine kill button status
Ignition request on/off Thus can be seen with the gear en-
gaged by pressing the starter button: in
this condition the ECU reads the igni-
tion permissive (Axone reads ON) but
does not start the engine. For instance,
if the right dimmer switch circuit is inter-
rupted, although the ignition button is
pressed, the condition of this parameter
does not change (it stays OFF)
Purge valve on/off
Lambda sensor active on/off Lambda sensor operational
Cut off on/off Activates at certain engine speed /
throttle position etc. combinations
Throttle self-teaching com-
pleted on/off If throttle position self-teaching does
not end successfully, the parameter =
OFF
Engine heating phase on/off
Power latch
completed
on/off When power to the ECU is switched off,
a series of parameters is stored during
the power latch
Reduced operation on/off In case of serious engine malfunction, it
will be run at only less than a set en-
gine speed
Gear in neutral yes/no
Switch on/off Parameter not assigned
Side stand up/down
Clutch engaged yes/no
Initialization error no / engine speed >0 / vehicle
speed >0 / stepper error / throttle
out of range / battery voltage / wa-
ter temperature / idling control mo-
tor off List of the potential reasons why the
throttle self-teaching or initialization
failed
Purge valve status lambda on / threshold not reached
/ Cut off active / rpm threshold /
speed / Injector defect / HW cut off
/ not active Purge valve related reasons why the
lambda sensor does not activate; only
for CALIFORNIA version, check opera-
tion
Lambda sensor initialization / wait after start / sen- Lambda sensor status