APRILIA RS 660 2020, Руководство пользователя, Страница: 72 / 196

02_91
5.1) Change user code (Change user code)
This function may be used to modify the existing code (you must be in possession of
the code itself in order to do this). The user code enables engine start even in the
event of an immobiliser system fault. On a new vehicle, the user code is set by default
as five zeros (00000) and the message "INSERT YOUR PERSONAL CODE" appears
on the display for ten seconds when the ignition is switched on.
This function allows you to change the code itself and remove this message.
A value (from 0 to 9) is shown for the first figure of the code (furthest to left) on the
display. Press MODE UP or MODE DOWN to modify the value. Press MODE SET
briefly to confirm the selection. Repeat the operation for all the digits. Once the code
is confirmed, the new code is shown steadily on the display to let the user verify that
the code has been entered correctly. Turn the ignition off and then on again to unlock
the dashboard. The last code set may be modified again in future. Access the setting
mode again, enter the last user code used (OLD CODE), then enter a new user code
(NEW CODE) as described previously.
02_92
5.2) Code recovery (Code recovery)
This function must be used should it be necessary to change the user code when the
user no longer remembers the current code. Both keys stored in the vehicle memory
are needed to access this function.
Once the function is activated, pressing the MODE SET briefly displays the message
"INSERT KEY 1", requesting identification of the first key. Insert the key. If the correct
key is recognised within twenty seconds, the message "INSERT KEY 2" is shown on
the display. Insert the second key. If the second key is also recognised within twenty
seconds, the dashboard resets the user code to the default code (five zeros - 00000).
Enter the new user code following the "CHANGE USER CODE " procedure.
72
2 Vehicle