pag.
11
G)
Return the ignition key to the OFF position and wait for the LED to start flashing in order to confirm the
second digit. Repeat steps H- I and L for the remaining digits;
Once you have confirmed the fifth digit in the new OVERRIDE code, the alarm system will emit four dual-
tone buzzer sounds. Leave the key in the ON position for the new code entered to be displayed by way of
a sequence of LED flashes after a 3” pause. It is important to wait for verification of the new code so you
know immediately if any mistake was made when entering the digits.
NB:
Make a note of the newly customised OVERRIDE code in the space provided on the printed form found
on the last page of this manual. Cut out the page as shown and keep in a safe place.
EMERGENCY DISARMING VIA THE OVERRIDE CODE
Should your remote control be stolen or misplaced, stop working, or have a flat battery, you can disarm your
alarm system by following an emergency procedure using the 5-digit OVERRIDE code shown on the CODE
CARD.
NB: THIS PROCEDURE WILL INEVITABLY TRIGGER AN ALARM AS IT INVOLVES USING THE IGNITION
KEY.
Each product has a different, factory-set OVERRIDE code, but this may be changed to a code of your choice.
(See the "CUSTOMISING THE OVERRIDE CODE" section)
Follow the procedure below in order to disarm the alarm system:
Turn the ignition key to the ON position (+15) and check that the LED is now lit without flashing;
A)
Return the ignition key to the OFF position
and wait for the LED to start flashing in order
to confirm the first digit in the override code;
CAUTION: THE NUMBER OF FLASHES
MUST MATCH THE FIRST DIGIT IN THE
CODE (E.G. IF THE FIRST DIGIT IS 1, TURN
THE KEY TO THE ON POSITION WHEN
THE LED HAS FLASHED ONCE)
Confirm the digit by turning the key to the ON
position;
B)
Return the ignition key to the OFF position and wait for the LED to start flashing in order to confirm the
second digit; confirm the digit and repeat steps C-D and E for the remaining digits.
If you have entered the correct code, the alarm will be disarmed once you have confirmed the fifth digit. You
must start up the engine to confirm the whole operation; if you fail to do this, the alarm will remain armed.
In this case, you must repeat the whole procedure.
Caution: the control unit will enter a 30-minute block if incorrect codes are entered 3 times.
CUSTOMISING THE OVERRIDE CODE
You can customise the OVERRIDE code to a code of your choice by following the same procedure described
above when the alarm system is disarmed:
Within 10 seconds, turn the ignition key from the OFF position to the ON position (+15) 3 consecutive times;
the LED will light up without flashing and you will hear a buzzer sound by way of confirmation;
A)
Return the ignition key to the OFF position and
wait for the LED to start flashing in order to confirm
the first digit in the override code. Confirm the digit
by turning the key to the ON position (E.g.: if the
first digit is 1, turn the key to the ON position when
the led has flashed once);
B)
Within 3” return the ignition key to the OFF
position and wait for the LED to start flashing in
order to confirm the second digit; confirm the digit
and repeat steps C-D and E for the remaining digits.
Once you have confirmed the fifth digit, leave the
key in the ON position (+15): if you have entered
the correct code, the alarm system will emit four
dual-tone buzzer sounds and the LED will turn off.
ENTERING THE NEW CODE:
F)
Return the ignition key to the OFF position and
wait for the LED to start flashing in order to confirm
the first digit in the new code;