APRILIA 8140172, Руководство по обслуживанию и ремонту

Страница: 53 / 279

SERVICE AND SETTING UP
2 - 26
RSV mille
#(%#+).' !.$ 4/00).' 50 4(%
#,54#( &,5)$
Carefully read 0.2.1 (PRECAUTIONS AND GENERAL
INFORMATIONS) and 1.2.6 (CLUTCH FLUID).
Check the clutch fluid every 7500 km (4687 mi) or 8
months change it every two years.
a
CAUTION
If the clutch control lever features excessive free
play, if it is excessively spongy or in the event of air
bubbles in the circuit, bleed the system, see 2.21
(BLEEDING THE CLUTCH SYSTEMS).
The leak of cluth fluid damages painted or plastic
surfaces.
Before setting out, make sure that the hoses are not
twisted or holed and that there are no leakage from
the connectors.
Do not use or mix different types of silicone or oil-
based liquids.
Do not use clutch fluids taken from old containers, or
not sealed.
Make sure that neither water nor dust accidentally en-
ter the circuit.
CHECKING
NOTE
Position the vehicle on the side stand on firm
and level ground.
◆ Keep the vehicle in vertical position, so that the fluid
contained in the tank (1) is parallel to the plug (2).
◆ Make sure that the fluid level exceeds the “MIN” mark.
MIN = minimum level
MAX= maximum level
◆ If the fluid does not reach the “MIN” mark, provide for
topping up.
TOPPING UP
a
CAUTION
The fluid may flow out.
Do not operate the clutch control lever if the reservoir
plug is loose or has been removed.
a
WARNING
Avoid any prolonged exposure of the clutch fluid to
the air.
The clutch fluid is hygroscopic and when in contact
with the air it absorbs its humidity.
Leave the clutch fluid tank open ONLY for the time
necessary for topping up.
◆ Unscrew and remove the plug (2).
NOTE
Do not shake the vehicle, in order not to spill flu-
id while topping up.
◆ Remove the gasket (3).
a
CAUTION
Do not put additives or other subtances into the fluid.
If you use a funnel or other similar items, make sure
that they are perfectly clean.
3
2
1
MAX MAX
MIN MIN
MAX
MIN
◆ Top up the reservoir (1) by adding clutch fluid, see 1.6
(LUBRICANT CHART), until reaching the correct level
included between the “MIN” and “MAX” marks.
a
CAUTION
Do not exceed the “MAX” mark while topping up.
◆ To reassemble the components, follow the reverse or-
der.