APRILIA 1115-2, Руководство по ремонту

Страница: 57 / 386

SERVICE AND SETTING UP
2 - 8
RSV mille
-5,4)&5.#4)/. #/-054%2
KEY
A) Left multifunction digital display (speedometer -
odometer).
B) Multifunction computer programming push buttons.
C) Right multifunction digital display (coolant tempera-
ture - clock - battery voltage - chronometer - diagnos-
tic).
When the ignition key (1) is rotated to position “
2
”, the fol-
lowing warning lights come on on the dashboard:
– red line warning light LED “
max ” (2);
– red engine oil pressure warning light LED “
.
” (3),
which remains on until the engine starts.
The pointer (4) of the revolution counter shifts to the max-
imum value (rpm) set by the user. After about three sec-
onds the red line warning light LED “
max ” (2) goes off;
the pointer (4) of the revolution counter returns to its initial
position.
The writing “
(),
” (5) appears on the right side of the
multifunction display for three seconds.
In this way the component operation is tested.
a
CAUTION
After the first 1000 km (625 mi) and successively eve-
ry 7500 km (4687 mi), the writing “SERVICE” (5a) ap-
pears on the right display.
In this case contact an
APRILIA
Official Dealer, who
will carry out the operations indicated in the regular
service intervals chart, see 2.1.1 (REGULAR SERV-
ICE INTERVALS CHART). To make the writing “SERV-
ICE” disappear, press the “LAP” push button (6) and
then the push button
r
and keep them pressed for
about five seconds.
With the ignition key (1) in position “
2
” the standard set-
tings on the dashboard are the following:
Right display : Clock (7), coolant temperature in °C (8).
Left display : Instantaneous speed in km/h (9), trip 1 (trip
odometer) (10), total kilometres/miles odometer (11).
Upon installation of the battery or of the 30A main fuses:
– the revolution counter pointer (4) makes twelve clock-
wise clicks, thus checking the operation of the revolu-
tion counter itself;
– the instantaneous, maximum and average speed func-
tion is set in “ km/h ”;
– the coolant temperature is set in °C;
– the digital clock is set to zero;
– the red line is set at 6000 rpm, indicated by the coming
on of the red line warning light LED “ max ” (red) (2).
NOTE
If necessary, carry out the appropriate adjust-
ments.
2.3.1 SEGMENT OPERATION CHECK
◆
Press the push buttons
l
and
k
at the same time.
◆
Rotate the ignition key (1) from position “
1
” to position
“
2
”.
All the segments (13) (13a) will remain on until the push
buttons
l
and
k
are released.
- 00
Release 00/2002-10