APRILIA 1115-2, Руководство по ремонту

Страница: 134 / 386

ENGINE
3 - 19
RSV mille
3.3.1 POSITIONING THE ENGINE ON THE ENGINE
SUPPORT STAND
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATIONS).
NOTE
Have the appropriate special tools
m
to hand:
– aprilia part# 8140188 (engine support) (1);
– aprilia part# 8140187 (engine support stand) (2).
◆
Remove the entire engine from the frame, see 3.3 (RE-
MOVING THE WHOLE ENGINE FROM THE FRAME).
a
WARNING
The entire engine and hoist setup must be stable, en-
suring that the subsequent operations can be per-
formed safety.
◆
Raise the hoist arm, lifting the engine at approximately
1 meter from the ground.
◆
Install the engine support (1) on the engine.
a
WARNING
Tighten the screws (3) thoroughly, since the incom-
plete tightening of the screws (3) may cause the en-
gine to fall down, with consequent damage to per-
sons, property and the engine itself.
◆
Screw and tighten the three screws (3).
◆
Assemble the engine support stand (2) with the engine
support (1) and insert the safety pin (4) in the appropri-
ate seat.
◆
Clear and clean the area on which the stand-engine as-
sembly will be positioned.
◆
Using the hoist, move the stand-engine assembly to
the desired area.
◆
Lower the hoist arm and rest the stand-engine assem-
bly on the area prepared for this purpose.
a
WARNING
Before releasing the hoist straps, make sure that the
stand-engine assembly is stable. The overturning of
the assembly may damage persons, property and the
asembly itself (engine included).
◆
Release the stand-engine assembly from the coupling
of the hoist (5).
$)3!33%-",).' 4(% %.').%
For the disassembly of the engine, refer to the service
and repair manual, see 0.4.1 (ENGINE SERVICE AND
REPAIR MANUALS).
Release 00/2002-10
- 00