APPA 76, Инструкция по эксплуатации

Страница: 11 / 22

10
4. If the capacitance of the capacitor you are going to measure is specified, set the appropriate range. If it is not,
start with the 200pF range. If an over range is indicated, go to the next range up. Continue doing so until the
over range annunciator disappears and a measurement is shown. This will ensure that you are using the range
offering the maximum possible resolution.
5. With low-value wire-ended capacitors and/or capacitors for PCB mounting, set the meter to "0" and insert the
capacitor terminals straight into the measuring sockets. Where it is not possible to use the measuring sockets with
the capacitors you wish to measure, plug the test leads into the (+) and (-) capacitance input terminals and apply
the leads to the capacitor terminals.
6. An over range is indicated by a "1" as the highest digit and no other digits shown.
7. The capacitance value can be read straight off the display because the meter automatically inserts the decimal
point and the range it has selected can be read off at the same time.