APlusLift MT1500, Руководство по установке и инструкции по эксплуатации

Страница: 12 / 20

www. apluslift .com
Phone: 800-616-9618 Text: 425-300-2600 Email: help@apluslift.com
Copyright
C
2020
TM
12 of 2
0
4.2 ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagrams on pages 1 2 - 1 4 .
4.3 Determine T he Proper Lift Location:
1.
D
o
not use the
l
ift on any asphalt surface. Make sure the
l
ift is used on a dry, oil/grease free,
flat, level, concrete surface capable of supporting the weight of the Lift and the equipment. Do
not use the
l
ift on concrete expansion seams or on cracked, defective concrete.
2.
Make sure to check the desired location for possible obstructions such as a low ceiling,
overhead lines, adequate working area, access ways, exits, etc.
4.4 Unpacking & Setup
1.
2. Open the shipping container, then remove the
r
amp and shipping boards out of the packaging.
CAREFU LLY T U RN TABLE U PRI GH T I N T O OPERAT I N G POSI T I ON BEFORE
REM OV I N G T H E SH I PPI N G WI RE
ON
T H E CABLE REST RAI N T FROM
SCI SSOR M ECH AN I SM .
MAKE SURE THAT THE ROLLER GUIDES CONNECTED TO THE
CYLINDER ROD ARE ON THEIR TRACKS CORRECTLY BEFORE RAISING
THE LIFT!
Connect the foot-operated air valve to 90-1 2 0 psi air supply. The lift may be damaged and/
or personal injury may result if the pressure exceeds the maximum psi rating.
Stand clear of the lift table, and depress the UP side of the foot valve to raise the table.
To lower the table, raise lift and then lift the safety lock bar from safety latch and lower to
the next position or to the floor.
Place the dropout cover over the dropout opening.
Insert the ramp mounting pins into the holes at the end of the table to mount the approach
ramp.
The safety lock bar can be held up by attaching it to the safety lock bar clip underneath the
table assembly.
4 .
I nst a lla t ion
Figure 4.1
Mounting points for the
APlusLift
MT1500 & MT1500X a pproach
r amps.
Please make sure the approach
ramp is correctly installed at all
mounting point s before using the lift table.
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
Route h ose from here ONLY.
Otherwise clearance may not
be enough.
3
.
4
.
5
.
6
.
7
.
8
.
9
.