www.
apluslift
.com
Phone: 800-616-9618
Text: 425-300-2600 Email: [email protected]
Copyright
C
2020
TM
10 of 2
0
The warnings, precautions, and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. The operator must understand that
common sense and caution are factors which cannot be built into this product, but must
be supplied by the operator.
ONLY AFTER CAREFULLY READING ALL OF THE
PRECEDING SAFETY WARNINGS SHOULD YOU ATTEMPT
TO INSTALL OR OPERATE THIS LIFT!
3 .
Sa fe t y Wa rnings
Improper installation or operation can cause injury or damage!
1.
Read this installation and operation manual in its entirety before attempting to install
the lift.
Manufacturer or
d
istributor assumes no responsibility for loss or damage of any kind,
expressed or implied, resulting from improper installation or use of this lift. Always use an
a
uthorized
APlusLift
professional installer.
2.
All
persons
using this equipment must be responsible, qualified, and carefully follow the
operation and safety guidelines contained in this manual.
3.
A level floor is required for proper lift installation and operation. The leveling pipe must be
installed through the main front roller assembly for proper lift operation as well.
4.
DO NOT
install this lift on any asphalt surface. Only on concrete surface a minimum of
4"
thick and 3,000 psi tensile strength with steel or fiber mesh reinforcement.
5.
DO NOT
install this lift over concrete expansion joints or cracks. (Check with your building
contractor or
architect.)
6.
DO NOT
install this lift on an upper floor without written authorization from your building
contractor or
architect. Should only be installed on
the first floor without a
basement.
7.
DO NOT
attempt to lift only
a portion
of
a vehicle
. This lift is intended to
simultaneously
raise
the entire body
of the
vehicle
only.
8.
NEVER lift any
persons
or equipment containing
persons
. This lift is designed to lift
empty equipment only.
9.
ALWAyS roll equipment up the ramp on the center part of the table
. Roll equipment
onto the table lifting surface in line with the
f
ront
w
heel
c
lamping
v
ise. This lift is designed
to
only be center-loaded. Note
that
loading in the center of the table may cause serious
bending
and metal
failure
to the frame and support rods of the table.
LOAD ONLy ON THE
CENTER
LINE
. Please see
the c
enter
l
ine in drawing on page 5 for reference.
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
