Aplex VIPAC-8 Series, Руководство пользователя

Страница: 21 / 84

VIPAC-8XX Series User Manual
20
2.4 Jumpers Setting and Connectors
1. BAT1 :
(1.25mm Pitch 1x2 wafer Pin Header) 3.0V Li battery is embedded to provide power for
CMOS.
Pin# Signal Name
Pin1 Ground
Pin2 VCC_RTC
2. SW1(1,2,6):
(Swich),ATX Power and Auto Power on jumper setting .
SW1 Mode
Pin1 on Auto Power on (Default)
Pin1 off ATX Power (option)
Pin6 on Default
CMOS clear swich, CMOS clear operation will permanently reset old BIOS settings to
factory defaults.
SW1 CMOS
Pin2 OFF NORMAL (Default)
Pin2 ON Clear CMOS
Procedures of CMOS clear:
a) Turn off the system and unplug the power cord from the power outlet.
b) To clear the CMOS settings, use the swich to Pin2 on for about 3 seconds then move
the swich Pin2 off.
c) Power on the system again.
d) When entering the POST screen, press the <DEL> key to enter CMOS Setup Utility to
load optimal defaults.
e) After the above operations, save changes and exit BIOS Setup.
3. DC_IN:
(5.08mm Pitch 1x3 Pin Connector),DC9V ~ DC36V System power input connector
。
Pin#
Power Input
（
DC_IN
）
Pin1 DC+9V~36V
Pin2 Ground
Pin3 FG