Apex Digital XA1200, Руководство по эксплуатации

Страница: 19 / 153

19
Operating or towing the XA1200 with faulty safety
devices is extremely dangerous. Failure to correct any
of these components could result in severe personal
injury or death.
SAFETY WHILE REFUELING
Diesel fuel is flammable and explosive under certain circumstances. Observe these
safety practices:
•
Always handle fuel in a well-ventilated area.
•
Do not smoke or allow open flames or sparks in the vicinity.
•
Do not refuel with the engine hot or running.
• Avoid physical contact with diesel fuel.
• Regularly inspect fuel system components.
• If fuel or fumes are noted while operating the XA1200, the cause should be
determined immediately.
• Never open the fuel lines or loosen the injectors if the applicator runs out of fuel.
•
Avoid inhalation of exhaust particulate dust. Wear a dust mask. If respiratory
irritation or discomfort occurs, leave the dusty area. Utilize breathing assistance or
oxygen if necessary,
•
Elevated concentrations of metals in the form of dust, soot, and contaminates are
contained in these filters. Health regulations may exist for the materials found in
these filters such as Zinc, Molybenum, polynuclear aromatic sulfur, and iron.
•
Proper disposal of the exhaust dust and filter are required. Dispose of in accordance
with local and environmental regulations.
•
Diesel particulate filter maintenance MUST be completed by appropriately trained
personnel.
PRE-OPERATION INSPECTIONS
The Pre-Operation Inspection that an operator does before starting a piece of equipment
is the single most important responsibility of the day. The operator is the key component
in the walk-around and it is their responsibility to solicit help as required if areas of
distress or concern are noted. Cell phones and digital pictures are extremely helpful
when communicating potential problems or concerns.
Many operators overlook vital aspects of the walk-around such as fluid type and
quantity. To maximize the effectiveness of a fluid it must be the proper viscosity and
quality at starting temperatures. Next in degree of importance is the fluid quantity. Too
much fluid can be as harmful as too little fluid. Be sure all fluids are in the proper level
range and refer to the Fluid Specifications and Tank Capacities Chart on Page - of this
manual whenever replacing or adding fluids.
•
The walk-around should be performed before each shift and before moving the
machine or even starting the engine.