Apex Digital XA1200, Руководство по эксплуатации

Страница: 28 / 153

28
Ignition Switch
The ignition switch is located on the Operator Control Panel,
below the Controller Master Display.
STARTING PROCEDURE
Do not operate the starter for more than 10 seconds at
a time. If engine does not start, allow at least 60
seconds cool-down period between starting attempts.
Not following these guidelines may cause damage to
the starter.
If the key switch is released before the engine has
started, allow the starter and engine to completely
stop before re-engaging the starter. This will prevent
possible damage to the starter and/ or engine flywheel.
To start the engine, perform the following steps:
1. Insert the key into the ignition switch and turn the
key to the RUN position.
2. Wait for the Home Screen to appear and verify the
system is ready.
3. Turn the key to START position and release once
the engine has started.
In cold start situations the display will show the “Wait
to Start” message. Wait until this message disappears
to crank the engine.
Pre-Operation Warm-Up
Allow the cold engine to run at idle for 5 minutes or more while the engine coolant and
hydraulic temperatures rise to the operating temperature. In extremely cold conditions it
may take 30 minutes or more for all fluids to reach normal temperature levels.