A P E X
D I G I T A L
H T - 1 8 0
11
1
2
3
Open the cover.
OPERATING WITH THE REMOTE CONTROL
Operating HT-180 with the remote control.
The remote control must point at the remote sensor, in order for the HT-180
to function correctly.
Distance: Maximum of 7m from the front of the remote sensor.
Angle: Approximately 30˚ from each direction.
*Please do not place the remote sensor towards any light source such as direct sun-
light or illumination. If you do so, the HT-180 will malfunction.
Insert batteries (AAA size).
Make sure to match the + and - on
the batteries to the marks inside the
battery compartment.
Close the cover.
PREPARING THE REMOTE CONTROL
To operate the HT-180, you must first place the batteries in the remote control.
NOTICE
FOLLOW
INSTRUCTIONS
BELOW
BECAUSE
INCORRECT
USE
OF
BATTERIES
MIGHT
CAUSE
THEM
TO
LEAK
OR
CORRODE
.
• Do not place the batteries in the wrong direction.
• It is dangerous to charge/heat/open or short-circuit the batteries.
• Do not leave dead batteries or mix old/new batteries in the remote control.
• When not using the remote control for a long duration of time, remove the batteries.
• If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.
Index of Parts and Controls
Continued
A P E X D I G I T A L
H T - 1 8 0
11
30˚ 30˚
