Apex Digital Cleco mPro4000GC, Руководство по установке

Страница: 6 / 20

mPro400GC replaced by mPro400GCD
6 P2434JH | 2019-08 Apex Tool Group
3
EN
3 mPro400GC replaced by mPro400GCD
If mPro400GC-P/-M is replaced by mPro400GCD-P/-M, certain things need to be considered. Below are
various scenarios and procedures for exchanging controller types.
3.1 Primary/Master controller
Scenario
• mPro400GC-P/-M is replaced by mPro400GCD-P/-M.
• No Secondary controllers connected.
Conditions for new system layout
Procedure
Save parameters from mPro400GC-P/-M:
1. Select Navigator > Administration > Save parameters .
→ The Save parameters dialog opens.
2. Select the storage location and confirm with <OK>. The parameters can be stored on an internal stor-
age device (CF card) or an connected USB drive.
3. Press <All> to save all parameters.
4. Disconnect mPro400GC-P/-M and connect mPro400GCD-P/-M. See documentation P2300HW or
P2309HW.
Set up mPro400GCD-P/-M:
1. Start mPro400GCD-P/-M.
2. Ensure that hybrid-capable software is used. The software has to be S168813-1.8.0 or newer.
3. Ensure that the current version of the operating system is used. The operating system has to be 2.7 or
newer.
Load parameters from an internal storage device (CF card) or a connected USB drive to
mPro400GCD-P/-M:
1. If the parameters have been saved on the CF card, insert the old CF card into mPro400GCD-P/-M. If
the parameters have been saved on the USB drive, insert the USB drive into mPro400GCD-P/-M
2. Select Navigator > Administration > Load parameters .
→ The Load parameters dialog opens.
3. Select the previously saved parameters and confirm with <OK>.
4. Press <All> to load all parameters.
Old system layout New system layout
Fig. 3-1: Primary/Master controller mPro400GC Fig. 3-2: Primary/Master controller mPro400GCD
Type Indication
Software version mPro400GCD-P/-M: S168813-1.8.0 or newer.
Operating system 2.7
mPro400GC-P/
mPro400GC-M
mPro400GCD-P/
mPro400GCD-M