10
OPERATING PROCEDURES
4.
Press the increase or decrease button to adjust the bottom heater set
temperature level. The set temperature is adjustable from 50 to 280 C in this
type of operation. To temporarily turn off the bottom heater simultaneously
press both the “Increase” and “decrease” button
(
#3
&
#4
from the control
panel display see page 8)
. The bottom display will show “OFF” indicating the
bottom heater is now turned off.
5.
To view the actual internal temperature read by the Top heater and the
bottom heater’s internal temperature probe, repeatedly press the selection
button until the top display shows the actual value of the top heater internal
temperature followed by a suffix “
d
”. The number displayed in the middle row
followed by a suffix
“E”
is for the bottom heater actual internal temperature
.
The bottom display shows the actual temperature of the soldering iron , it is
followed by a suffix “
F
”.
6.
To view the actual temperature read by the three external temperature
sensor, repeatedly press the selection button until the top display shows the
top heater external temperature prob’s actual temperature followed by a
suffix
“A”
. The middle display will show external temperature probe b’s
actual measured temperature followed by a suffix
“b”.
And the bottom
display would show the actual measured temperature of the external
temperature
probe C
. It is followed by a suffix
“C”.
Note: External temperature probes are labeled. Top heater external probe
is labeled A, while the other two is labeled b and C. The displayed actual
temperature reading’s suffix corresponds to the labels.
E. TYPE “1” OPERATION
Before proceeding with this type of operation, attach the top external
temperature
probe A
to one corner of the BGA or IC to be reworked. Then attaché
the external temperature
probe b
to the underside of the PCB to be worked on,
preferably not near the are of the BGA or IC to be reworked on but not directly
underneath the BGA or IC.. The external temperature
probe C
can be placed near
any area of interest.
7
LEGEND:
1 — Digital Display
7 — Solder Iron Connector
1.a Top Display
8 — Main Power Switch.
1.b Middle Display
9 — Power Cord.
1.c Bottom Display
10 — Fuse Holder.
2 — Selection Button
11 — Top Heater Power Cord
3 — Increase Button/ Enter Button
12 — Top Heater Sensor Connector
4 — Decrease Button
13 — Top Heater Power Connector
5 — Status LED
14 — Top Heater Sensor Cord
6 — External Sensor Connector
15 — Top Heater External Sensor
***
(Expansion for future versions, May not be available for current releases )
16 — Lamp Attachment.***
Suffix guide:
A -
Actual Temperature of Sensor “A” / Set Temperature of Top Heater.
b -
Actual Temperature of Sensor “b” / Set Temperature of Bottom Heater.
c -
Actual Temperature of Sensor “c”.
D -
Actual Temperature of Top Heater Internal Sensor.
E -
Actual Temperature of Bottom heater Internal Sensor.
F -
Set/Actual Temperature of Solder Iron.
1.a
4
3
2
6
8
5
Front Panel
Back Panel
11
12
1.b
1.c
7
10
9
13
14
15
16
CONTROL PANEL GUIDE
Top Heater
