AOR AR8000, Руководство по эксплуатации

Страница: 23 / 115

AR8000 operating manual
23
NEWUSER / EXPERT
The default setting is NEWUSER (new user), this is the initial recommended
setting. If EXPERT status has not been selected then a smaller number of
options are available which simplifies operation when first exploring the
features and facilities of the AR8000.
[CLEAR] - Clear entry key
This key will cause data entry to be cancelled should a mistake be accidentally
typed and forces an escape from the menu “back to search, scan of VFO
mode” whichever had been previously selected.
There is no second function for this key.
Should you experience a programming / operational problem with the AR8000,
you may reset the microprocessor by holding the [CLEAR] key while powering
up the receiver. Your memory bank and search bank data will remain intact
but any linked banks, frequency pass data etc will be lost... use only as a last
resort.
[PASS] [S SET] Frequency-channel pass (skip) /
Select Scan / Step offset
This key has many operations depending upon the condition of the receiver at
the moment it is operated:
In Search mode
When the search process stops on an unwanted busy channel (noise etc)
press the [PASS] key to register the frequency as a PASS (lock out) frequency.
Any subsequent search of the search bank will not stop at this frequency, it will
be skipped.
To edit the search pass frequencies press [FUNC] [PASS].
In MEMORY RECALL or SCAN mode
PASS - In the “M.RE” (memory recall) mode or when the scan stops on a
channel, press [PASS] to register the memory channel as a “PASS CHAN-
NEL”. The letter “p” will be added to the left of the frequency to indicate the
channel will be passed (skipped). To release the pass status, press [PASS]
again while in M.RE mode, this will remove the letter “p” and reinstate the
channel so that it may be scanned along with other channels in the memory
bank.
Note: If you PASS a memory channel which is currently “tagged” for SELECT
SCAN, the letter “p” will be hidden behind the letter “s” for select scan.
SELECT SCAN - In the “M.RE” (memory recall) mode or when the scan stops
on a channel, press [FUNC] [PASS] to “tag” (register) the memory channel as
a “SELECT SCAN CHANNEL”. The letter “s” will be added to the left of the
frequency to indicate the channel has been added to the current SELECT