AWARD BIOS
1-6
1.2
ACPI Suspend to Hard Drive
For a detailed installation procedure please refer to the following procedure to
enable ACPI Suspend to Hard Drive on the AOpen MX3W-V motherboard.
First please check if your system meets the following requirements, then
follow the procedure step by step.
System Requirement
1. AOZVHDD.EXE 1.30b or later (http://www.aopen.com.tw/tech/mbdrv/
default.htm#Suspend to Hard Disk Drivers).
2. Delete config.sys and autoexec.bat.
I. Fresh installation
1. Execute "Setup.exe /p j" to install Windows 98.
2. After Windows 98's installation is completed, go to Control Panel --> Power
Management.
a. Set "Power Schemes -> System Standby" to "Never".
b. Click on "Hibernate" and select "Enable Hibernate Support" then
"Apply".
c. Click on the "Advanced" tab, you'll see "Hibernate" on "Power Buttons".
Note that this option will only be seen after step b mentioned above has
been completed, otherwise only "Standby" and "Shutdown" will be
shown. Select "Hibernate" and "Apply".
3. Run AOZVHDD utility.
a. If you assign the whole disk to your Win 98 system (FAT 16 or FAT 32), please run
"aozvhdd /c /file" in DOS mode. Please remember sufficient free space has to be
reserved in the disk, e.g. if you have 64 MB DRAM and 16 MB VGA card installed,
the system needs at least 80 MB free space. The utility will locate the space
automatically.
b. If you assign an individual partition for Win 98, please run "aozvhdd /c
/partition". Of course, the system needs to provide unformatted an
empty partition.
4. Reboot system.
