IEEE 1394 Connectors
With IEEE1394 Chip on board (AGERE 1394), having its data transfer rate up to
400Mb/s, this interface can connect to devices that require high data transferring
performance such as digital camera, scanner or others IEEE 1394 devices. Please
use appropriate cables to connect IEEE1394 devices.
Pin 1
Dual Gigabit LAN onboard
On the strength of Dual Marvell Gigabit LAN chip on board, the motherboard
provides 10/100/1000Mbps Ethernet for home and office use. The Ethernet RJ45
connector is located on top of USB connectors. The right hand side LED indicates
link mode, it lights in yellow whenever linking to network. The left hand side LED
indicates the transfer mode and it lights in green when data is transferring in
100Mbps (never lights while in 10Mbps), but lights in orange when transferring in
Gigabit’s mode. To enable or disable this function, you may simply adjust it
through BIOS.
Transferring (Left)
Green 100Mbps
Orange Gigabit mode
Linking (Right)
Yellow
Front Audio Connectors
If the housing has been designed with an audio port on the front panel, you’ll be
able to connect onboard audio to front panel through this connector. By the way,
please remove 5-6 and 9-10 jumper caps from the Front Audio Connector before
connecting the cable. Please do not remove these 5-6 and 9-10 yellow jumper
caps if there’s no audio port on the front panel.
Serial ATA Connectors
To connect a serial ATA disk, you have to have a 7-pin serial ATA cable. Connect
two ends of the serial ATA cable to the serial ATA header on the motherboard and
the disk. Like every other traditional disk, you also have to connect a power cable.
Please be noted that it is a jumper free implement; you don’t need to set jumpers
to define a master or slave disk. When serial ATA hard disks are installed on serial
ATA ports, the one connected on SATA1 will be set as the first boot device
automatically.
Please note that it doesn’t support Hot-Plug in function.
Pin 1
AUD_GND
AUD_VCC
1
Front Audio Connector
AUD_RET_R
KEY
AUD_FPOUT_L
NC
AUD_FPOUT_R
AUD MIC BIAS
AUD_MIC
AUD_RET_L
Pin 1
Pin 1
10
GND
TPB-
TPA+
GND
+12V (Fused)
1
9
TPA-
TPB+
+12V (Fused)
2
SHIED GND
SATA1
SATA2
SATA4 SATA3
SATAII
