-L*A1AW 6/12-
[Insulation between Channels]
[Analog Output Connection]
To LP4-WW-10P crimped
transmission line link connector
FK4-125-100
LP4-WR-10P
Master unit
FK2-125-100
Master unit
Analog output device
24V*
IN
0V
24V
IN
0V
Analog output unit
Analog GND
+OUT
Analog output sensor
0V
+OUT
+24V
24V
IN
0V
Pin1
Pin2
Pin3
■
Analog side applicable connector
■
Analog-side pin arrangement
■
Analog-side connection example
Ex.) Mini clamp wire mount plug
37103 - **** - *00 FL
(3M Japan Limited)
Up to
100 mA
DP,DN
24V,0V
LP2-PWH-10P crimped
To transmission line link connector
24V (Green), 0V (White)
tip protection
DP (Red), DN (Black)
When using two-polarity connector, protect the tip so that
24V (green) and 0V (white) are not short-circuited.
LP2-BR-10P
LA-A1AW
DP,DN
LA-A1AW (CH insulated base AMP)
LA-A1AW
LB-S24
LB-A1AW
LB-S24
LB-A1AW (CH insulated extension AMP)
LB-S24 (Power supply unit)
LB-S24 (Power supply unit)
Configuration example)
Block diagram)
Example of supplying power in a batch)
DP DN
IN 0V
24V
24V 0V
IN 0V
24V
Analog output connection
Analog output connection
[Transmission Line Connection]
To LP4-WW-10P crimped
transmission line link connector
FK4-125-100
LP4-WR-10P
Local
power
supply
[Base unit
transmission line color]
DP,DN
24V,0V
Example that a power supply unit is not used)
Example of local power supply)
To LP4-WW-10P crimped
transmission line link connector
FK4-125-100
LP4-WR-10P
DP,DN
24V,0V
Master unit
Master unit
A/D Circuit
A/D Circuit
Control
circuit
Control
circuit
Control
circuit
Control
circuit
Control
circuit
Control
circuit
When connecting only the analog input, use it to LA-A1AW and LB-A1AW by
connecting as it is.
When 24V supply is required for the analog output device, connect a dedicated
power supply unit (LB-S24) next to each unit and then perform extension.
When power is supplied to the transmission 24V, 0V, it is output to the analog
input connector after passing through the power supply unit (insulated).
Connect the transmission line of the base unit of the analog input unit to the
transmission line from the master.
The base unit's 24V and 0V are used to supply 24V to the load from the each
CH analog input connector with the power supply unit together.
■
Link connector pin layout
1
2
3
4
DN
DP
0V
24V
Black
Red
White
Green
Pin number Details Line color
DP
DN
: Red
: Black
24V
0V
: Green
: White
[Base unit
transmission line color]
DP
DN
: Red
: Black
24V
0V
: Green
: White
[Base unit
transmission line color]
DP
DN
: Red
: Black
24V
0V
: Green
: White
The LP connector (link connector) is a
mixed-contact type connector.
You can link connectors of the same
type to one another to easily perform
"connections" or "branching."
* When supplying power to the sensor side, connect the power supply unit
(LB-S24).