23
BASIC OPERATIONS
Turn On/ Off FM Radio
When in standby, press
key, the top left corner of the LCD will display "
"
icon, then press
key. The LCD will displays
"FM ON"
and the current FM
on the same frequency band. L2 and U2 must also be used on the same frequency band, When the
VFO frequency is between L1 and U1 or L2 and U2, the radio will scan between them when scanning is
activated. When the VFO frequency is outside of L1 and U1 or L2 and U2, the radio will scan the whole
frequency range of the radio .
In VFO mode, enter your frequency range “lower border limit”. Press the
1.
key, the top left corner
of LCD will display the " " icon, then press the
key to enter the manual channel programming
mode, the channel number will begin flashing.
Press the
2.
/
buttons until the Channel number displays the “lower border limit” channels (either
L1 or L2) (They are found in the channel menu after Channel 199 and Before Channel 001)
Press the
3.
key, the top left corner of LCD displays " " icon, and hold the
key until the
transceiver emits confirmation beep. Your “lower border limit” channel has been programmed
successfully.
Repeat the above steps to enter the “upper border limit” channel (either U1 or U2) .
4
.
NOTE:
In order for the borders to operate correctly, L1 and U1 must in same band (VHF or UHF) and L2 and U2 must
in same band (VHF or UHF). You can set both borders in the same band and when you start scanning from a
frequency that is within the current border the scanning will stay within that border. When you start scanning
outside of either border the scanning will go through the entire radio frequency range.
